DESCRIPTION:BFD-1000 specifically designed for use as a black (white) line finding, especially for complex black and white line, cross black and white line detection, it has 6 high sensitivity infrared sensor (5 road patrol line, a road barrier shield), black and white line to the accurate recog..
Address of this module can be changed. By default, the address is '0100011'.
You can connect the solder bridge in the ADDR box. Then the address becomes '1011100'.
You can also do other configurations. For more information, you can refer to the datasheet.
DESCRIPTION:The LX1972 is a low cost silicon light sensor with spectral response that closely emulates the human eye. Patented circuitry produces peak spectral response at 520nm, with IR response less than ±5%, of the peak response, above 900nm. ..
DESCRIPTION:The CNY70 is a reflective sensor that includes an infrared emitter and phototransistor in a leaded package which blocks visible light.APPLICATION:Optoelectronic scanning and switching devices i.e., index sensing, coded disk scanning etc. (optoelectronic encoder assemblies). L..
DESCRIPTION:This is a small micro switch sensor designed for the Arduino. It could be directly connected to the IO Expansion shield. It integrates the pull-up resistor and the status indicator LED onboard. That makes it easier for testing.The miniature snap-action micro switch with roller lever ..
DESCRIPTION: Fingerprint scanners are awesome. use a key when you have one right at the tip of your finger? Unfortunately, they're usually unreliable or difficult to implement. Well not anymore! We've found this great fingerprint module from ADH-Tech that communicates over TTL Serial so you..
DESCRIPTION:GP2Y1010AU0F is a dust sensor by optical sensing system.
An infrared emitting diode (IRED) and an phototransistor are diagonally arranged into this device.
It detects the reflected light of dust in air.
Especially, it is effective to detect very fine particle ..
FEATURES:1. Size: 11 mm x 27 mm2. Low power consumption, the power supply voltage of 2.5 V ~ 5 V, working current is microamps level3. Good linear4. High sensitivity5. High stability6. Wide detection range: 240 nm to 370 nm7. The big Angle: 130 degrees8. Schottky type..
FEATURES:BH1750FVI ROHM chip
Power supply: 3-5 v
Data range: 0-65535
Sensor built-in and bitad converter
Direct digital output, bypassing the complicated calculation, omit calibration
Do not distinguish between ambient light
Close to the visual sensitivity of spectral characterist..
DESCRIPTION:Pulse sensor is used to test the heart rate sensor, students, artists, athletes,
creators, games or mobile terminal developers can develop heart-related and
interactive works. Sensor can be worn on the finger or earlobe, can be connected
with Ard uino line ..
DESCRIPTION:PCB size:1.52cm x 2.22cm
Working Voltage: 5 Volt DC
Output: 4-5 Volt DC
On detecting a laser signal, output goes at high level (5V) until laser signal is there.NOTE: This sensor is non-modulator, to be used indoors away from any bright light or direct s..