This is the XBee 3mW Wire Antenna Series 2C module from Digi. Series 2C improves on the power output and data protocol. These modules allow a very reliable and simple communication between microcontrollers, computers, systems, really anything with a serial port! The modules also support both Point to point and multi-point networks. Note: XBee S2C variants can function on 802.15.4(Proprietary), Digi Mesh, and ZigBee Mesh Protocol, you will need to load the appropriate firmware using XCTU. Note: Series 1 and Series 2 XBee modules have the same pin-out. However, the Series 1 modules cannot communicate with Series 2 modules Features: 3.3V @ 33mA RF 250 Kbps, Serial up to 1 Mbps Data Rate 3.1mW output ( +5 dBm) 200 ft (60 m) Indoor Range/Urban Range 4000 ft (1200 m) Outdoor/Line of Sight Range Built-in antenna Fully FCC certified 4 10-bit ADC inputs 15 digital IO pins 128-bit encryption Local or over-air configuration AT or API command set
Write a review
Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: