Description• CJMCU-9833 AD9833 is a programmable waveform generator capable of generating a frequency 0-12.5MHZ sine, triangle, square wave signal.• Easy to adjust, clocked clock is 25MHz, precision 0.1Hz, clock frequency is 1MHz, the precision is up to 0.004Hz.• Frequency excitation / waveform gene..
GY-9833 AD9833 Programmable Sine Square Wave DDS Signal GeneratorThe AD9833 is a low power, programmable waveform generator capable of producing sine, triangular, and square wave outputs. Waveform generation is required in various types of sensing, actuation, and time domain reflectometry (TDR) appl..
style="box-sizing: content-box; padding: 0px; margin: 0px;">Two independent PWM generators can set the frequency, duty cycle;The wide frequency range, high accuracy;Can serial communication.First, the module description: Frequency is divided into three ranges: XXX (no decimal point): th..
Size: 20mm*40mm **Function: to generate different frequency square wave or square wave(1) power supply input voltage: 5V-12VDC. when 5V power supply, the output current is about 10MA; when 12V power supply, output current can be left in 30MA Right; (2) frequency: 5 bands (actual value) **JUMPER J1: ..
• The Si5351 is an I2C configurable clock generator that is
ideally suited for replacing
crystals, crystal oscillators, VCXOs, phase-locked loops (PLLs), and fanout
• Based on a PLL/VCXO + high resolution Multisite fractional divider
XY-KPWM PWM Signal Generator 1 Channel 1Hz-150KHz PWM Pulse Frequency Duty Cycle Adjustable Module LCD Display ON Off ButtonXY-KPWM signal generator is a device that provides electrical signals at a variety of frequencies, square wave, and output levels.It is used as a signal source or excitation so..
2 sine wave and 2 square wave output
AD9850 Frequency: 0-40MHz
After the 20-30MHz frequency harmonics increases, the waveform will become unclean.
Square Wave: 0-1MHz
Low-pass filter with 70MHz, so the waveform better than SN
Parallel and serial data input can be selecte..
1,An onboard chip NE555
2, a single-channel signal output, the output is approximately fifty percent duty cycle square wave
3, onboard adjustable resistance, adjust the output frequency can be controlled resistance
4, on-board power indicator
5, the working voltage: 5 ~ 1..
An onboard chip NE555
A single-channel signal output, the output is approximately fifty percent duty cycle square wave
Onboard adjustable resistance, adjust the output frequency can be controlled resistance
On-board power indicator
The working voltage: 5 ~ 12V
the scope of this module:1 is used as a square wave signal generator generates a square wave signal used for experimental development.2 to drive a stepper motor for generating a square wave drive signal.3 adjustable pulse generated for use by MCU.4 adjustable pulse generation, control circuitry asso..