DEVELOPMENT BOARDS

  Product description: Main changes from the older version: Add two rows of the holes for the pins. So it can be connected with normal Dupont line.  Add 3 rows of the holes for wiring.  Change the in-line package of ATMEGA32..

Package Include: 1X ATMEL ATmega328  CH340G BOARD with  USB CABLE Free Product description: Main changes from the older version: Add two rows of the holes for the pins. So it can be connected with normal Dupont..

Package Include: 1X ATMEGA328P 5V/16M  + 3 x sets of header pins    Product description: Mini Pro is a micro-controller board. It has 14 digital input / output pins (of which 6 can be used as PWM outputs),&nb..

Package Include: 1X ATmega32U4 5V/16M  + 2 x sets of header pins    Product description: 1). ATMega 32U4 running at 5V/16MHz2). Supported under IDE v1.0.13). On-Board micro-USB connector for programm..

DESCRIPTION:Microcontroller chip: ATtiny13A  Mini USB interface or pin power supply.  All the IO port leads and marked.  On-board ISP interface.  Reliable reset circuit.   ..

DESCRIPTION:Size：21mm*28m Clock Speed 16 MHz Operating Voltage 5V DC Digital I/O Pins 10 PWM Channels 4 Analog Input Channels 5 UART 1 I2C 1 Micro USB 1 Flash Memory 32 KB of which 4KB used by bootloader SRAM 2.5 KB EEPROM 1 KB Microcontroller ATmega32u4..

DESCRIPTION:Crystal X1 is a standard 12MHz, USB host USB device is higher than the required frequency accuracy, X1 error requirement is less than 0.4 ‰, ordinary 12MHz crystal basically meet the requirements. It is strongly recommended to shorten the length of the relevant lead to reduce interfe..

DESCRIPTION:Compared to other versions of the Arduino using a separate USB-Serial converter chip, the Leonardo innovatively uses a single-chip solution. Only with a Atmega32u4 USB communication and control. The Leonardo differs from all preceding boards in that the ATmega32u4 has built-in USB co..

DESCRIPTION:The LilyPad For Arduino is a microcontroller board designed for wearables and e-textiles. It can be sewn to fabric and similarly mounted power supplies, sensors and actuators with conductive thread. The LilyPad Iduino can be programmed with the software of Arduino. *Note*, the LilyP..

DESCRIPTION:   8K Byte of In-System Programmable Program Memory Flash 512 Bytes In-System Programmable EEPROM 512 Bytes Internal SRAMDiameter:25mm  ..