Menu
Your Cart

Gas Detection Module Ethanol Mq-3

DESCRIPTION:

Sensitive material MQ-3 gas sensor is used to clean the air in the lower conductivity of tin dioxide (SnO2). When present in the environment in which the alcohol vapor sensor , a conductivity sensor with increasing concentration of alcohol gas in air is increased . Using a simple circuit to convert the change in conductivity of the gas concentration corresponding to the output signal. High MQ-3 gas sensor sensitivity to alcohol , gasoline resistant to interference , smoke, water vapor . This sensor can detect various concentrations of alcohol atmosphere , is a low-cost sensors for a variety of applications
 
Module Applications:
Other places ethanol vapor detection of alcohol ( ethanol ) testing, field testing for motor vehicle drivers and other non- drinking and operating personnel , but also for
Module Features :
1 , using high-quality dual-panel design, with power indicator and TTL signal output instructions;
2 , the switching signal having a DO (TTL) output and analog output AO ;
3, TTL output valid signal is low . ( Low-level signal when the output light can be directly connected to the microcontroller or relay module )
4 , analog output voltage , the higher the concentration the higher the voltage .
5 , for the detection of alcohol have better sensitivity.
6 , there are four screw holes for easy positioning ;
7 Product dimensions : 37MM (L) * 23MM (W) * 23 (H)
8 , has a long life and reliable stability
9 , rapid response and recovery characteristics
 
Electrical properties:
Input voltage : DC5V Power consumption ( current ): 150mA
DO output : TTL digital 0 and 1 ( 0.1 and 5V)
AO output :0.1-0 .3 V ( relative to pollution ) , the maximum concentration of a voltage of about 4V
Special note: After the sensor is powered , needs to warm up around 20S, measured data was stable , heat sensor is a normal phenomenon , because the internal heating wire , if hot is not normal .
 
Wiring:
1, VCC: positive power supply (5V)
2, GND: power supply is negative
3, DO: TTL switching signal output
4, AO: analog signal output

Write a review

Please login or register to review
We are Upgrading...
Sorry, We are currently closed and will reopen on the 21st of July. We apologize for any inconvenience this may cause.