HC-SR04 Ultrasonic Module Compatible with ARDUINO, RASPBERRY PI, AVR, PIC, 8051, etc.
1.Working Voltage : 5V(DC)
2.Static current: Less than 2mA.
3.Output signal: Electric frequency signal, high level 5V, low level 0V.
4.Sensor angle: Not more than 15 degrees.
5.Detection distance: 2cm-450cm.
6.High precision: Up to 0.3cm
7.Input trigger signal: 10us TTL impulse
8.Echo signal : output TTL PWL signal
use IO port TRIG to trigger ranging. It needs 10 us high level signal at least
Module will send eight 40kHz square wave automatically, and will test if there is any signal returned.
If there is signal returned, output will be high level signal via IO port ECHO. The duration of the high level signal is the time from transmitter to receiving with the ultrasonic.
Testing distance = duration of high level*sound velocity(340m/s) / 2
You can use the above calculation to find the distance between the obstacle and the ultrasonic module.
The module has a blind spot of 2cm(very near). So obstacle held too closely will not be detected.
Write a review
Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: