Menu
Your Cart

Tilt Sensor Module Tilt Switch Module For Robot Smart Car

Tilt Sensor Module Tilt Switch Module For Robot Smart Car
  • Stock: In Stock
  • Brand: xcluma
  • Model: BE-000229
  • Weight: 4.00g
  • MPN: BE-000229
Rs35.00
(GST +18%Extra)

ONE MODULE DESCRIPTION:

  • The angle sensor can sense the change object
  • Operating Voltage3.3V-5V
  • Output Type Digital switching output (0And1)
  • With fixed bolt hole for easy installation
  • Small platesPCBSize:3cm * 1.6cm

 

TWO MODULE INTERFACE SPECIFICATION (3Wire )

  • VCC External3.3V-5VVoltage ( directly with5vSCM and3.3vMicrocontroller is connected )
  • GND ExternalGND
  • DO Small board digital output interface (0And1)

Note:AOIn the mouth this is invalid , do not do any processing.

 

THREE INSTRUCTIONS:

  • Tilt sensorMECOriginal tilt switchSW-460DHigh sensitivity, generally used to detect the object angle changes .
  • Module without inclination or tilt angle of less than the threshold value,DOPort output high, when the tilt angle sensor exceeds the threshold , the moduleD0Output low.
  • Small board digital outputD0Can be directly connected with the microcontroller through the microcontroller to detect high and low , thereby detecting an object angle changes.
  • Small board digital outputDOOur relay module can directly drive , which can be composed of a tilt switch.

FOUR MODULE APPLICATIONS:

  • Tire pressure monitoring system(TPMS), Bicycle lights , digital photo frame rotation, screen rotate, flip video camera , anti-theft system
  • Five test instructions
  • Use shop51Boards and tilt sensor module test

WIRING:

ModuleVCCPick Development BoardVCC

ModuleGNDPick Development BoardGND

ConnectedVCCAndGND, Module power indicator lights

The module level light up the desktop, the module slowly rotating in one direction , the switch indicator lights , and then rotate the module in the opposite direction , back to the original state , the switch lights off. This phenomenon is explained , changing the angle sensor can trigger module , so that the switch indicator lights.

 

Another item which comes with a51Procedures used to detect tilt sensor module digital interfaceD0High and low

Are described as follows :

Wiring:

ModuleVCCPick Development BoardVCC

ModuleGNDPick Development BoardGND

ModuleD0Pick Development BoardP0.1

SCM:STC89C52

Send data to serial baud rate :9600

Phenomenon: change the angle of the trigger module , serial constantly sending01While the switch indicator light ;

No angle change does not trigger module , serial data is not sent , lights out.

Write a review

Please login or register to review
We are Upgrading...
Sorry, We are currently closed and will reopen on the 21st of July. We apologize for any inconvenience this may cause.